Dogtra 1900 Series Manuel d'utilisateur

16BUTTON FUNCTIONWhen either the orange or gray stimulationbutton is pressed and the toggle is set on“Nick” the receiver emits a single, rapid pulseof

Turning on the Collar ReceiverThe ON/OFF button is on the bottom of thereceivers. Push and hold the button for twoseconds until the LED light, located

20BATTERY CHARGERThe battery charger and charging cablesallow you to charge both the transmitter andreceiver at the same time. The battery charger isd

22TESTING3. Turn the transmitter on by pressing the bluebutton on the right side of the transmitter untilthe LCD screen illuminates. The LCD screensho

24FITTING THE COLLAR ON THE DOGIMPROPER FITA loose fit can allow the collar to movearound on the dog’s neck. When this happens,the contact points may

Battery Charging Procedure 1. Attach the charging cables to both thetransmitter and receiver(s), as shown onpage 26. 2. Plug the charger into a 120-v

2928CHARGING THE BATTERIES3. After charging, cover the battery chargingreceptacles with the rubber plugs on thetransmitter and receiver.4. The battery

METAL BELT CLIP ACCESSORY30METAL BELT CLIP ACCESSORYTo attach the metal belt clip to your transmitter,follow the steps below.The final result should l

BASIC MAINTENANCEBe sure that the rubber charging plugs arealways secured when the collar is in use. If yourplugs break or are ripped, please contact

34TROUBLESHOOTING GUIDE2. The LED indicator light comes on, but I donot feel any stimulation.- Your tolerance may be higher than yourdog’s. You may ne

MAIN FEATURESPRODUCT SAFETY AND HEALTHSTATEMENTSPACKAGE CONTENTSDESCRIPTION OF TRANSMITTER PARTSBUTTON FUNCTIONDESCRIPTION OF COLLAR/R

36WARRANTY AND REPAIR INFORMATION2-Year Limited Lifetime WarrantyDogtra Company provides the original purchaser with a 2-YEARWARRANTY for the 175NCP,

38WARRANTY AND REPAIR INFORMATIONhave been found damaged upon replacement and repair. Procedure for Repair WorkIf the unit is malfunctioning, please r

2Easy-to-use, ergonomic transmitter.Rheostat dial allows for gradual increases instimulation intensity with no jumps betweenlevels (0-127).Two-dog mod

TransmitterReceiver (two collar receivers for Dotra two-dog models)Battery charger and splitter cableTest lightOwner’s manualCarrying caseMetal

7DESCRIPTION OF TRANSMITTER PARTSTransmitter AntennaA short 2antenna is supplied with the transmitter.The antenna must be fastened to thetransmitter

8DESCRIPTION OF TRANSMITTER PARTSRheostat Intensity DialThe Rheostat Intensity Dial is located onthe top of the transmitter: (0) being the lowestlevel

10DESCRIPTION OF TRANSMITTER PARTSCare for LCD Transmitters in Cold Temperature In cold temperatures (10 degrees F orbelow), the Liquid Crystal Displa

12DESCRIPTION OF TRANSMITTER PARTSTransmitter Battery Charging Receptacle &Rubber PlugLocated on the backside of the transmitter,the charging rece

14BUTTON FUNCTION“Constant” ButtonThe “Constant” button is located on thebottom left. Pressing the “Constant” buttongives continuous stimulation as lo