Dogtra 2500B Series Manuel d'utilisateur

16DESCRIPTION OF TRANSMITTER PARTSCare for LCD Transmitters in Cold Temperature In cold temperatures (10 degrees F orbelow), the Liquid Crystal Displa

18DESCRIPTION OF TRANSMITTER PARTSTransmitter Battery Charging Receptacle &Rubber PlugLocated on the backside of the transmitter,the charging rece

20BUTTON FUNCTION“Constant” ButtonPressing the “Constant” button givescontinuous stimulation as long as the button ispushed, for up to 12 seconds. If

22BUTTON FUNCTION* NOTE : The locate button can be used inany mode you are in.Initial BeeperSoundPress 1stTime2 BeepsRun/PointMode-Dog running: Double

Transmitter Power ON/OFFThe button on the right side of thetransmitter is the “ON/OFF” button thatactivates the transmitter and LCD screen only.To tur

26DESCRIPTION OF COLLAR / RECEIVER PARTSReceiver ON/OFF Magnetic Red Dot To activate the receiver/collar, place thered dot on the back of the transmit

28DESCRIPTION OF COLLAR / RECEIVER PARTSReceiver Battery Charging Receptacle andRubber Plug On the inside of the collar receiver, next tothe collar st

30TESTING1. To activate the receiver/collar, place the reddot on the back of the transmitter to the reddot on the collar/receiver. Hold the two reddot

32TESTINGNOTE : The test light may not be visible if theintensity level is set below level ten.7. To make sure that your beeper is workingproperly, p

34TESTINGThe Dogtra 2502 T&B two-dog unit operatesjust like the Dogtra 2500 T&B single-dog unit.The difference between the one-dog and two-dog

OVERVIEWMAIN FEATURESPRODUCT SAFETY AND HEALTHSTATEMENTSPACKAGE CONTENTSDESCRIPTION OF TRANSMITTER PARTSBUTTON FUNCTIONDESCRIPTION OF

36FITTING THE COLLAR ON THE DOGIMPROPER FITA loose fit can allow the collar to movearound on the dog’s neck. When this happens, thecontact points may

Battery Charging Procedure Note : The unit has a partial charge when itleaves the Dogtra facility, upon receipt ofthe collar, be sure to give it a fu

The collar has arange of 1 mile. Depending on the way you useyour transmitter, the transmitter range may vary.Hold the transmitter away from your bod

BASIC MAINTENANCE43BASIC MAINTENANCEBe sure that the rubber charging plugs arealways secured when the collar is in use. If yourplugs break or are rip

45TROUBLESHOOTING GUIDE2. The test light comes on, but I do not feelany stimulation.- Your tolerance may be higher than yourdog’s. You may need to try

47WARRANTY AND REPAIR INFORMATIONprovides the originalpurchaser with a LIMITED LIFETIMEWARRANTY. Limited Lifetime Warrantybegins from the date of purc

49WARRANTY AND REPAIR INFORMATIONDogtra DOES NOT replace defective unitsor provide refunds for products purchased fromus after 30 days from the date o

51WARRANTY AND REPAIR INFORMATIONcompleted. For any questions concerning yourDogtra products call us Toll Free at 1-888-811-9111, M-F 8:30AM - 4:00PM,

52MEMO

2Beeper CollarThe remote trainingsystem will give you the ability to keep track ofyour dog’s location when he/she is out of sightor on point. The is

it double beeps every 2 seconds. By pushing theMODE button a second time, the unit will go intothe Point-Only mode. While the dog is moving, theunit w

6Fully waterproof collar/receiver andtransmitter.No bothersome external antenna on thecollar/receiver.One-charging system allows the transmitterand re

TransmitterReceiver (two collar/receivers for Dogtra two-dog models)Lithium Polymer Battery chargerand splitter cableTest lightOwner’s manualCa

10DESCRIPTION OF TRANSMITTER PARTSDESCRIPTION OF TRANSMITTER PARTStransmitter (2-dog)AntennaDog CollarToggle SwitchOn/Off MagnaticRed DotBattery Charg

12DESCRIPTION OF TRANSMITTER PARTSBeeper Sound Toggle Switch on the One-Dog ModelsThe one-dog model has a Beeper Soundtoggle switch on the face of the

14DESCRIPTION OF TRANSMITTER PARTSRheostat Intensity DialThe Rheostat Intensity Dial is located onthe top of the transmitter: (0) being the lowestleve