Dogtra eF-3000 Manuel d'utilisateur télécharger pdf (Page 18)

INSTALLATION

Make gradual turns at the corners with a radius of at

least 3 feet. This will provide a more consistent signal

field that will avoid confusing the dog in these areas.

IMPORTANT!

DO NOT

run fence wire within 6 feet parallel to

electrical, telephone, cable TV or other buried wire.

DO NOT run fence wire of one section within 10

feet of another section of fence wire or the signal may

cancel.

DO NOT run fence wire within 10 feet of a

neighboring e-Fence system’s boundary wire.

Driveways/Sidewalks

When crossing an asphalt driveway, make a 1/2-inch

deep cut across the driveway using a circular saw and

masonry blade. Close the crack with asphalt sealant

after the fence wire is placed in it. If an expansion joint

is available on driveway and sidewalks, place fence

wire in the joint and close it with outdoor caulk. When

crossing gravel, bury fence wire at least 3 inches deep.

PVC pipes or a garden hose can be used to protect the

wire. In water, anchor the wire with large rocks. Use

PVC piping or garden hose to protect the wire.

INSTALLATION

WIRE SPLICING

The wire connection must be waterproof

Do not use electrical tape, or soldered/twisted

wire nuts in this type of connection as it will cause

an intermittent signal or disarm the system. The

waterproof splices included in the

are designed to provide a

sealed connection between the wires. The insulation

on the boundary wire should not be stripped before

placing wire into the holes. To use the waterproof

splices, a single boundary wire is placed into one of

the three holes of the splices. The other single

boundary wire is placed into one of the other holes.

This should leave one extra hole that is not used. A

pair of pliers should be used to gently press down

on the top of the blue part of the splice.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24 25 26

Pas de commentaire

Dogtra eF-3000 Manuel d'utilisateur Page 18